Welcome

Thanks for visting! The table of contents are on the right. Archives for this blog are located at the bottom of the page.







Tuesday, August 2, 2011

Rock Rails-Installation/ Finishing the rails

The rock rails were only 50% done. The rocker panels were still exposed if the Jeep was on lean. So I took it down to my local fabrication geniuses, namely Offroad Connection. I knew they had it under control so I just took off (after a couple of hours).

When I returned Wayne had tacked on both sides and was getting ready to fuse it together permanently. He matched the tubing size to the tubing used in the front fenders and rear coffin rails. 1.5" rails with 1" struts.



Wayne getting ready to finish the welding. Wayne has helped me a lot throughout the years